Announcement

Collapse
No announcement yet.

Wiring Diagram

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • masternut
    replied
    Re: Wiring Diagram

    Mike thanks for the reply...
    JBEES has already sent me a diagram.

    Thanks Steve...

    Peanut

    Leave a comment:


  • MASTERMIKE
    replied
    Re: Wiring Diagram

    Hello Masternut,
    I have a small 12 lane center near me that has factory A-2's. I have not been there In qute a while but I think they Installed the amf accuscore with just lower key pads and overheads.
    If you have no luck finding wiring a diagram I would be glad to see If they have some.
    Mike

    Leave a comment:


  • masternut
    started a topic Wiring Diagram

    Wiring Diagram

    I need some help...I need to get a wiring diagram for accuscore Brunswick A-2 hook-up in electrical box.This system has the two tower switches and the single relay.

    Thanks in advance.

    Peanut

Topic Starter RibbonScript

Collapse

Adsense Classic 2

Collapse

Related Topics

Collapse

 

Super Bowl Funday!

This is how my day started. The note left by the night mechanic was "The cam needs adjustments. Table keeps going up and down."

...
 

Distributor Clutch Stop Blade Wear

Replaced this stop blade on an Edge machine at a private installation I service. It looks like this after 20,000 frames. The stop blade on the machine next to it looks new after...
 

Qubica BES-X Lane Advertising

Anyone know if/how to replace the BES-X "station ID" graphic that shows up before and after a video ad runs on the monitors? I'd much rather have it show our logo, especially...
 

Preventative Maintenance - Jet Back Booster & A2 Accelerator Control Boxes

I convert my booster control relays over to Plug-ins as they fail. They are the same as the Motor Start & Recycle relays which makes it very convenient.

...
 

Making TDM's adjustable.

I have some machines that the time delay cycles like right now when machine is triggered instead of the 3 sec delay. Would like to put in a potentiameter to correct this. Does...
 

Solderless relay conversion

Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...
Working...
X