No announcement yet.

As-90 Wiring diagram


Adsense Classic 1

  • Filter
  • Time
  • Show
Clear All
new posts

  • As-90 Wiring diagram


    Does anyone have a diagram of the wiring to install


  • #2
    Re: As-90 Wiring diagram


    What exactly are you installing? Certain components, the whole scoring system (consoles, front desk, cameras, overheads, data processors, pinsetter switches) I don't believe there is one 'master' wiring diagram to do this, you will need to get your hands on an as series scoring service manual. This won't exactly tell you how to do it but will tell you what each wire should look like and where it plugs into. If you have no experience with as series scoring you are going to have a lot of fun to put it in if it is a new install. I just went through replacing a lot of comonents and upgrading to a command network system and still have headaches [img]/content/btubb/images/%%GRAEMLIN_URL%%/frown.gif[/img]


    Topic Starter RibbonScript


    Adsense Classic 2


    Related Topics



    Super Bowl Funday!

    This is how my day started. The note left by the night mechanic was "The cam needs adjustments. Table keeps going up and down."


    Distributor Clutch Stop Blade Wear

    Replaced this stop blade on an Edge machine at a private installation I service. It looks like this after 20,000 frames. The stop blade on the machine next to it looks new after...

    Qubica BES-X Lane Advertising

    Anyone know if/how to replace the BES-X "station ID" graphic that shows up before and after a video ad runs on the monitors? I'd much rather have it show our logo, especially...

    Preventative Maintenance - Jet Back Booster & A2 Accelerator Control Boxes

    I convert my booster control relays over to Plug-ins as they fail. They are the same as the Motor Start & Recycle relays which makes it very convenient.


    Making TDM's adjustable.

    I have some machines that the time delay cycles like right now when machine is triggered instead of the 3 sec delay. Would like to put in a potentiameter to correct this. Does...

    Solderless relay conversion

    Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...