Announcement
Collapse
No announcement yet.
Switch scoring.
Collapse
Adsense Classic 1
Collapse
Adsense Classic 2
Collapse
Related Topics
Collapse
-
by Slayt812Hey anyone using this type of scoring??
-
Channel: Other Scoring Systems Discussion
11-15-2008, 05:51 PM -
-
by SnilloqI have got a call from a center Using switch scoring with Brunswick GS 92s. They seem to be having scoring problems on all or most lanes with them not scoring the correct number...
-
Channel: Other Scoring Systems Discussion
03-30-2013, 04:44 PM -
-
by brentman1Helping a friend fix a scoring problem on AS80 yesterday, had a 44/144 switch that had gotten messed up, he said he had some more switch clusters, and handed me one off the old...
-
Channel: Brunswick Scoring Systems Discussion
03-03-2011, 07:56 AM -
-
by sharpbowlerCan anyone tell me which connections in the J strip that the sw4 switch connects to.
-
Channel: Pinspotters AMF 82-30
04-08-2010, 05:52 PM -
-
by ThundermanI am helping an center with scoring issue. They have 82/30 with AS 90 scoring. They have two lanes that the 0 degree switch is showing open on the ccd scanner. The switches are...
-
Channel: Brunswick Scoring Systems Discussion
01-11-2015, 02:05 PM -
Bind in deck hook linkage
I'm having a problem with the deck holding hook lifting up and not engaging the pin during 2nd ball cycle. At first, I thought it was the detector but have ruled that out. If...
GS-X table bolts/stud
I know I'm not the only one who has had the table bolts literally shear off. I cannot explain where there would be a force strong enough to do this to the bolts.
Other that...
Other that...
Not scoring when ball speed "ball detection" is enabled
I have a pair that won't score if ball detection is turned on, but when I turn it off the scoring works right away.
On the ball speed sensor, the green light indicates...
On the ball speed sensor, the green light indicates...
GSX pins dumping in table at front
Hi everybody, I'm looking for some guidance. My GSX machines have a problem with pins gathering in the table in front of the #3 pinholder. One or two lanes are worse than the...
Idler shaft
One of our lanes has a bad bearing assembly for the distributor pulley. The idler shaft that the pulleys sit on has been damaged where it sits on the bearing. I took the assembly...