No announcement yet.

need help with mendes


Adsense Classic 1

  • Filter
  • Time
  • Show
Clear All
new posts

  • need help with mendes

    been working at orbit lanes for 2 months now. all of a sudden the scorring software at the front desk went haywire. the hole system is screwed up. none of the lanes are showing up and i figured a way to bypass everything but it is a pain in the ass. we have no book, no software cd, no backup, no nothing and ive never used mendes before. the owners bought the bowling alley as is. evertime you turn the system on it says software is out of date. mendes is out of bussiness so im not sure what to do.

  • #2
    Re: need help with mendes

    hey I knwo I guy that has all kinds of that stuff,, tell what ya you need and I`ll P.M. him, hes in Iowa,,, I used to work for him and he had mendes scoring,with lots of parts,,, [email protected]---------email me


    Topic Starter RibbonScript


    Adsense Classic 2


    Related Topics



    Distributor Clutch Stop Blade Wear

    Replaced this stop blade on an Edge machine at a private installation I service. It looks like this after 20,000 frames. The stop blade on the machine next to it looks new after...

    Qubica BES-X Lane Advertising

    Anyone know if/how to replace the BES-X "station ID" graphic that shows up before and after a video ad runs on the monitors? I'd much rather have it show our logo, especially...

    Ball Damage at my wits end

    We have been getting ball damage on a pair of lanes and we are at our wits end trying to find the problem. Every time we think we have found it we get another ball with damage...

    GS-X table bolts/stud

    I know I'm not the only one who has had the table bolts literally shear off. I cannot explain where there would be a force strong enough to do this to the bolts.
    Other that...

    Preventative Maintenance - Jet Back Booster & A2 Accelerator Control Boxes

    I convert my booster control relays over to Plug-ins as they fail. They are the same as the Motor Start & Recycle relays which makes it very convenient.


    Solderless relay conversion

    Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...