Announcement

Collapse
No announcement yet.

camera and pin setter adjustments

Collapse

Adsense Classic 1

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • DarkDays
    started a topic camera and pin setter adjustments

    camera and pin setter adjustments

    What do you guys find to be the best camera and pin setter parameters settings to be? I'm trying to get rid of most respots. Most of our linage is league bowling and around 60 percent of my calls are respots. We currently have bowl land x with the t vision cameras and 82/70 pin setters.
    Current pin setter settings are
    1st ball delay 0
    first read 2.5
    2nd ball delay 0
    second read 2.5
    delay 15
    cm 30
    level 30
    reset time 13
    camera parameters are check regularly and they don't seem to be moving.
    From what I have seen a majority of the respots are single pins. This is from the pins wobbling or moving causing a miss count and a score correction, not so much a pin setter issue more a scoring issue.
    Any input would be great.

  • mickeygm
    replied
    Not the same equipment but settings should be similar. Note long "Reset" time as I have slowed machines down to sub-A speed. I do Not have TDM's. Qubica sets the triggering time. Need to have at least 3 Seconds before Scissor deck on first ball, or rake sweep on second ball contacts pins. (From the rule book: There shall be a minimum of three seconds between the time the ball reaches the pit and activates the cushion or back stop and the pin table descends and contacts the standing pins.) I do not have 90 degree over-travel so the 0.1 2nd ball delay.

    ALL Files Scanned with MALWAREBYTES PREMIUM Version 3.5.1.2522 and AVAST INTERNET SECURITY Version 18.6.2349

    10th Frame 4a C.jpg

    Leave a comment:

Topic Starter RibbonScript

Collapse

Adsense Classic 2

Collapse

Related Topics

Collapse

 

Upgraded Motor Contactor

Hey all. Just had a motor contactor go on one of our machines. I remember seeing new cube relays or solid state contactors we could replace them with. Anybody got a part number...
 

C1 Pinout drawing

Finished the C1 drawing.

The base for this came from a drawing made by Felix dated 2006.

Thanks Felix.




If you see any...
 

CCD Processor Move by Masternut

These are pictures submitted by "MASTERNUT" of a project in his bowling center where he moved his CCD processor boards from the location on the capping to the curtain...
Working...
X