Announcement

Collapse
No announcement yet.

Q-VISION Camera

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Q-VISION Camera

    Does anyone know if a T-Vision Camera Will Work On a Q-vision Board?

    I have a b ad Camera on my Q-vision and one of are other houses has T-Vision so I just wandered if i could use there camera?

  • #2
    No, the Q vision board requires the Okkio camera
    Regards,

    Billy T
    [email protected]

    Comment

    Topic Starter RibbonScript

    Collapse

    Adsense Classic 2

    Collapse

    Related Topics

    Collapse

     

    Distributor Clutch Stop Blade Wear

    Replaced this stop blade on an Edge machine at a private installation I service. It looks like this after 20,000 frames. The stop blade on the machine next to it looks new after...
     

    Qubica BES-X Lane Advertising

    Anyone know if/how to replace the BES-X "station ID" graphic that shows up before and after a video ad runs on the monitors? I'd much rather have it show our logo, especially...
     

    Ball Damage at my wits end

    We have been getting ball damage on a pair of lanes and we are at our wits end trying to find the problem. Every time we think we have found it we get another ball with damage...
     

    GS-X table bolts/stud

    I know I'm not the only one who has had the table bolts literally shear off. I cannot explain where there would be a force strong enough to do this to the bolts.
    Other that...
     

    Preventative Maintenance - Jet Back Booster & A2 Accelerator Control Boxes

    I convert my booster control relays over to Plug-ins as they fail. They are the same as the Motor Start & Recycle relays which makes it very convenient.

    ...
     

    Solderless relay conversion

    Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...
    Working...
    X