Announcement

Collapse
1 of 2 < >

No Replies to Posts

Special Instructions - Due to the nature of this forum we don't allow public replies to posts, please use the contact information in the post or send the originator a PM by clicking there their name select the activities tab and then click Private Message button.


Notice! - When making a post to this forum, it will be moderated and will not be visible until an Admin approves the post.

2 of 2 < >

Resume Tips - Keep It Simple (Click for more)

The right information in a resume will make or break the chances of being interviewed

A resume is skimmed by the reader in less than a minute… Keep it simple and to the point
See more
See less

A2 Ace looking for contract work in the Seattle / Tacoma area

Collapse

Adsense Classic 1

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • A2 Ace looking for contract work in the Seattle / Tacoma area

    30 years experience on all versions of Brunswick A. All scoring systems and lane conditioning machines. Competitive rates, top quality service. Several references available.

Adsense Classic 2

Collapse
 

Preventative Maintenance - Brunswick All - Bearing Life

In relation to the recent “B Shaft” failure, I thought I would throw this subject on the table for discussion. I remember when I attended a “Bearing Life” seminar long...
 

Preventative Maintenance Brunswick A Jets A2 - SC/Dk Pulley Assembly

Found a bad left needle bearing in the Scissor / Deck Cable Assembly at the Rear Wall House. Needle Bearings are falling out and there is a pile of metal under it. Been 30+...
 

Preventative Maintenance - Brunswick B-10's Hollar House

Took a trip back in time to the classic “Hollar House”. The lanes went in in 1908. There was no ABC but according to the current operator, Tom, it became sanctioned when...
 

Table support assembly

My night at part job all 32 lanes going of leagues no where to move. Table support assembly broke rod broke # 2 Cell and bent the heck out of wire channel. Changed the Cell,...
 

Foul Light LED Mod

Here is a mod I came up with for a foul light unit. I was able to remove the old indicator light bulbs and replace them with ultra bright white LEDs. This should work for about...
Working...
X