No Replies to Posts

Special Instructions - Due to the nature of this forum we don't allow public replies to posts, please use the contact information in the post or send the originator a PM by clicking there their name select the activities tab and then click Private Message button.

Notice! - When making a post to this forum, it will be moderated and will not be visible until an Admin approves the post.

See more
See less

Mechanic Needed


Adsense Classic 1

  • Filter
  • Time
  • Show
Clear All
new posts

  • lovebowling
    started a topic Mechanic Needed

    Mechanic Needed

    We are a 20 lane center in Alabama near the Ga. border. Great Bass fishing if you like to fish. We have Brunswick A2 pin setters. With Qubica scoring Good league house with weekend open play. We are closed two days during the summer and one day during the fall. Salary commensurate with knowledge. Looking to start asap. Will help with moving. Nice area, no snow, You can answer here
    or call 979-943-6283. Thanks
    Last edited by lovebowling; 09-15-2019, 07:38 PM.

Topic Starter RibbonScript


Adsense Classic 2


Related Topics



Bind in deck hook linkage

I'm having a problem with the deck holding hook lifting up and not engaging the pin during 2nd ball cycle. At first, I thought it was the detector but have ruled that out. If...

GS-X table bolts/stud

I know I'm not the only one who has had the table bolts literally shear off. I cannot explain where there would be a force strong enough to do this to the bolts.
Other that...

Not scoring when ball speed "ball detection" is enabled

I have a pair that won't score if ball detection is turned on, but when I turn it off the scoring works right away.

On the ball speed sensor, the green light indicates...

GSX pins dumping in table at front

Hi everybody, I'm looking for some guidance. My GSX machines have a problem with pins gathering in the table in front of the #3 pinholder. One or two lanes are worse than the...

Idler shaft

One of our lanes has a bad bearing assembly for the distributor pulley. The idler shaft that the pulleys sit on has been damaged where it sits on the bearing. I took the assembly...