Announcement

Collapse
No announcement yet.

Look for a Brunswick A2 Head Mechanic

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • james1289
    started a topic Look for a Brunswick A2 Head Mechanic

    Look for a Brunswick A2 Head Mechanic

    Park Ten Lanes
    4393 Park Ten Dr. Diamondhead, Ms. 39525

    MUST HAVE Brunswick A2 pinsetter experience

    Maintains bowling lanes, pinsetters, pins, ball returns, bowling balls, scoring equipment and all other related mechanical components.

    Performs regular servicing and preventative maintenance procedures on all bowling equipment.

    Clean, repair and adjust automated scoring equipment.

    Identifies replacement parts and supplies; prepares orders.

    Performs major rebuilds and overhauls of equipment as necessary.

    Maintains accurate records of parts, costs and machine performance.

    Train and oversee hourly pin chaser employees.

    Job Type: Full-time

    Please submit to the link below
    https://www.indeed.com/job/bowling-h...4661b6203b445a

Topic Starter RibbonScript

Collapse

Adsense Classic 2

Collapse

Related Topics

Collapse

 

Super Bowl Funday!

This is how my day started. The note left by the night mechanic was "The cam needs adjustments. Table keeps going up and down."

...
 

Distributor Clutch Stop Blade Wear

Replaced this stop blade on an Edge machine at a private installation I service. It looks like this after 20,000 frames. The stop blade on the machine next to it looks new after...
 

Qubica BES-X Lane Advertising

Anyone know if/how to replace the BES-X "station ID" graphic that shows up before and after a video ad runs on the monitors? I'd much rather have it show our logo, especially...
 

Preventative Maintenance - Jet Back Booster & A2 Accelerator Control Boxes

I convert my booster control relays over to Plug-ins as they fail. They are the same as the Motor Start & Recycle relays which makes it very convenient.

...
 

Making TDM's adjustable.

I have some machines that the time delay cycles like right now when machine is triggered instead of the 3 sec delay. Would like to put in a potentiameter to correct this. Does...
 

Solderless relay conversion

Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...
Working...
X