No announcement yet.

I can't stay logged in


Adsense Classic 1

  • Filter
  • Time
  • Show
Clear All
new posts

  • I can't stay logged in

    If the site accepts your login name and password but then when you try to make a post or access a member only area of the site and it tells you that you do not have permission or are not logged in.

    Typically this problem is caused by a corrupt cookie in your browser or you security settings are not letting store a cookie in your browser. Cookies store your login information so you stay logged in between pages and to make your login quicker each time you visit the site. If there is a problem a cookie or one cannot be stored you will get the message you are describing.

    You need to first remove any old cookies in your browser from

    Once that is done if the problem still occurs then you need to make sure you browser is set to use cookies.

    If it is set to use cookies depending on how strict your security settings are you may have to put in your trusted web sites list for your browser to store a bowltech cookie.

    Below are some links to popular browsers and cookie tips.

    Microsoft Internet Explorer
    Google Chrome

    Mike Wilson
    Bowl-Tech Inc.

Adsense Classic 2


Preventative Maintenance - Brunswick All - Bearing Life

In relation to the recent “B Shaft” failure, I thought I would throw this subject on the table for discussion. I remember when I attended a “Bearing Life” seminar long...

Preventative Maintenance Brunswick A Jets A2 - SC/Dk Pulley Assembly

Found a bad left needle bearing in the Scissor / Deck Cable Assembly at the Rear Wall House. Needle Bearings are falling out and there is a pile of metal under it. Been 30+...

Preventative Maintenance - Brunswick B-10's Hollar House

Took a trip back in time to the classic “Hollar House”. The lanes went in in 1908. There was no ABC but according to the current operator, Tom, it became sanctioned when...

Table support assembly

My night at part job all 32 lanes going of leagues no where to move. Table support assembly broke rod broke # 2 Cell and bent the heck out of wire channel. Changed the Cell,...

Foul Light LED Mod

Here is a mod I came up with for a foul light unit. I was able to remove the old indicator light bulbs and replace them with ultra bright white LEDs. This should work for about...