Announcement

Collapse

No Replies to Posts

Special Instructions - Due to the nature of this forum we don't allow public replies to posts, please use the contact information in the post or send the originator a PM by clicking there their name select the activities tab and then click Private Message button.

See more
See less

Wanted-parted out Solid State Chassis (5 board version-bare) for AMF 8270

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Wanted-parted out Solid State Chassis (5 board version-bare) for AMF 8270

    Looking for a parted out AMF 8270 SS Chassis (5 board version w/Elco Mask connectors). Barebones without cards is preferred. Does not need to work and does not need any relays, or T1, memory module etc. Just needs to have a case with a good motherboard that has Elco Mask connectors (green) and C1/C2A connectors with wiring to motherboard. Not concerned on the condition of the connectors as long as they are in 1 piece.

    I have 8 AMF8270 machines with 8 SS Chassis. Would like to have a spare. I will put my own designed MP card into it with Triac motor control.

Topic Starter RibbonScript

Collapse

Adsense Classic 2

Collapse

Related Topics

Collapse

 

Preventative Maintenance - A Jets A2 - Elevator & Pits

All this work just to clean under the elevator !!??? LOL A friend is replacing a number of his elevators as the left hand triangle plate brackets are breaking. Rather than...
 

Preventative Maintenance - A Jets A2 - Ball Wheel Belt Question

A friend was looking at his ball wheel belt which stated it was 208" long, (Pic 1). He was pretty sure that it is a B205 belt which should be 205" long. The answer...
 

MONITOR COLOR ISSUE!!

my appologies if Ive posted this in the wrong area, this is my second post on this site, Ive got a 10 lane center ( 5 pairs ) and on lanes 3&4, I am having a problem with...
 

Pin spot is off

I'm currently working at a 38 Lane center. Of those 38 lanes only a few are having this issue.

I'm currently trying to get all the lanes to have perfect pin spots...
 

Idler shaft

One of our lanes has a bad bearing assembly for the distributor pulley. The idler shaft that the pulleys sit on has been damaged where it sits on the bearing. I took the assembly...
Working...
X