No announcement yet.

Envoy won't return


Adsense Classic 1

  • Filter
  • Time
  • Show
Clear All
new posts

  • Envoy won't return

    I have a Brunswick Envoy Lane machine and have ran into a issue with it not returning once it reaches the pit. There is no error message. Listening to the machine I can hear that it does not pick up the duster cloth like usual before its return. I have checked and cleaned the end of lane sensor and it seems to be okay. Thanks.

  • #2
    Does it run into the pit?
    Or does it just stop at the end of the lane?


    • #3
      It just stops at the end of the lane.


      • #4
        I would still suspect the end of lane sensor.
        Check your height and sensitivity adjustments.


        • #5
          After troubleshooting and eliminating the end of lane sensor as the issue I went onto the end of lane speed adjustment. Page 79 of the Envoy Lane Machine manual walked me through what to look for and how to correct it. The back of the machine was not reaching ~2" past the 2-3 pin spots. I had to increase the End of Lane Speed Adjustment +4 to get it to the correct position. Problem fixed.


          • #6
            Thanks for the good corrective action description.


            Topic Starter RibbonScript


            Adsense Classic 2

            widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

            Preventative Maintenance - A Jets A2 - Elevator & Pits

            All this work just to clean under the elevator !!??? LOL A friend is replacing a number of his elevators as the left hand triangle plate brackets are breaking. Rather than...

            Preventative Maintenance - A Jets A2 - Ball Wheel Belt Question

            A friend was looking at his ball wheel belt which stated it was 208" long, (Pic 1). He was pretty sure that it is a B205 belt which should be 205" long. The answer...


            my appologies if Ive posted this in the wrong area, this is my second post on this site, Ive got a 10 lane center ( 5 pairs ) and on lanes 3&4, I am having a problem with...

            Pin spot is off

            I'm currently working at a 38 Lane center. Of those 38 lanes only a few are having this issue.

            I'm currently trying to get all the lanes to have perfect pin spots...

            Idler shaft

            One of our lanes has a bad bearing assembly for the distributor pulley. The idler shaft that the pulleys sit on has been damaged where it sits on the bearing. I took the assembly...