No announcement yet.

Anyone have a grainger part number for vac motor?


Adsense Classic 1

  • Filter
  • Time
  • Show
Clear All
new posts

  • Anyone have a grainger part number for vac motor?

    Kegel p/n on motor is "153-0204"
    "2 stage bypass vac motor"
    120 vac

    thanks in advance!

  • #2
    Re: Anyone have a grainger part number for vac motor?

    Which machine is it for?


    • #3
      Re: Anyone have a grainger part number for vac motor?

      That part number (followed by a letter) is for the motor parts…Such as brushes, blade or the housing. It does not show up in the price list without a letter after the part #.

      We need to know what machine you have.


      Topic Starter RibbonScript


      Adsense Classic 2


      Related Topics



      Distributor Clutch Stop Blade Wear

      Replaced this stop blade on an Edge machine at a private installation I service. It looks like this after 20,000 frames. The stop blade on the machine next to it looks new after...

      Qubica BES-X Lane Advertising

      Anyone know if/how to replace the BES-X "station ID" graphic that shows up before and after a video ad runs on the monitors? I'd much rather have it show our logo, especially...

      Ball Damage at my wits end

      We have been getting ball damage on a pair of lanes and we are at our wits end trying to find the problem. Every time we think we have found it we get another ball with damage...

      GS-X table bolts/stud

      I know I'm not the only one who has had the table bolts literally shear off. I cannot explain where there would be a force strong enough to do this to the bolts.
      Other that...

      Preventative Maintenance - Jet Back Booster & A2 Accelerator Control Boxes

      I convert my booster control relays over to Plug-ins as they fail. They are the same as the Motor Start & Recycle relays which makes it very convenient.


      Solderless relay conversion

      Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...