Announcement

Collapse
No announcement yet.

Hpls

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Hpls

    Just a comment wear when the weather gets cold cpl of my lanes get the bowl effect more and have water spots after strip. Summertime I don't but now i'm starting to again. From N.mich.

  • #2
    Lane panels expand and contract under heat and cold like anything else. Worked a center once, here in Arizona, that had a couple of panels that bowed so much in cold weather that the lane machine buffer wouldn't even touch the lane surface, leaving a bare spot.

    Your only remedy is going to be to shim the panel, and make sure all the screws are secure.

    -- Larry

    Comment

    Topic Starter RibbonScript

    Collapse

    Adsense Classic 2

    Collapse

    Related Topics

    Collapse

    • Shannon
      Rock n Bowl
      by Shannon
      just a caustion to all centers. We currently just installed new lanes in our center and the installer informed us that we cant use the "Rock n Bowl" slogan, cuz someone...
      07-09-2000, 12:49 AM
    • the old dirt man
      lane condition's
      by the old dirt man
      with all the bowler's that like to whine and whine,because they can't stand in the same spot week after week,I think we should change the shot every week,then mabe they would...
      03-05-2001, 02:55 PM
    • John_Galt
      Karaoke on the lanes
      by John_Galt
      I've seen many places implement short-term karaoke in a separate bar with good success - short-term.
      Have heard about karaoke on the lanes, made possible via wireless microphone,...
      12-22-2004, 05:41 AM
     

    Distributor Clutch Stop Blade Wear

    Replaced this stop blade on an Edge machine at a private installation I service. It looks like this after 20,000 frames. The stop blade on the machine next to it looks new after...
     

    Qubica BES-X Lane Advertising

    Anyone know if/how to replace the BES-X "station ID" graphic that shows up before and after a video ad runs on the monitors? I'd much rather have it show our logo, especially...
     

    Ball Damage at my wits end

    We have been getting ball damage on a pair of lanes and we are at our wits end trying to find the problem. Every time we think we have found it we get another ball with damage...
     

    GS-X table bolts/stud

    I know I'm not the only one who has had the table bolts literally shear off. I cannot explain where there would be a force strong enough to do this to the bolts.
    Other that...
     

    Preventative Maintenance - Jet Back Booster & A2 Accelerator Control Boxes

    I convert my booster control relays over to Plug-ins as they fail. They are the same as the Motor Start & Recycle relays which makes it very convenient.

    ...
     

    Solderless relay conversion

    Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...
    Working...
    X