Announcement

Collapse
No announcement yet.

Mechanics switch

Collapse

Adsense Classic 1

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Mechanics switch

    Along time ago I posted this, and well here I go again!

    I'm unable to turn my machines on by the rear switch unless the mechanics override switch is in this position on the pinsetter interface. However, this will turn both pinsetters on.

    What I'm trying to accomplish is to just be able to use the rear switch on the machine and then leave the interface switch in the scorer position, but have independent control.

    Any ideas?
    My father told me to never get old...I should have listened!

  • #2
    Re: Mechanics switch

    Typically the rear mechanics override switch is spliced in parallel across the managers control switch (terminal 'C' and 'B' on CN3). If this has been changed restoring it will allow you to turn the machine on from the rear.

    Is this what you're after?
    Factory & Converted A-2 (US, Ger, Jap)
    Comscore ECT, Matrix & DuoHD
    Walker B, Sanction Standard, Original K, Flex Walker & Ikon
    Kegel C.A.T.S

    Comment


    • #3
      Re: Mechanics switch

      Yes..This is what I'm looking for. I'll give it a try tomorrow.

      Thanks Kanga!
      My father told me to never get old...I should have listened!

      Comment

      Topic Starter RibbonScript

      Collapse

      Adsense Classic 2

      Collapse

      Related Topics

      Collapse

       

      Upgraded Motor Contactor

      Hey all. Just had a motor contactor go on one of our machines. I remember seeing new cube relays or solid state contactors we could replace them with. Anybody got a part number...
       

      C1 Pinout drawing

      Finished the C1 drawing.

      The base for this came from a drawing made by Felix dated 2006.

      Thanks Felix.




      If you see any...
       

      CCD Processor Move by Masternut

      These are pictures submitted by "MASTERNUT" of a project in his bowling center where he moved his CCD processor boards from the location on the capping to the curtain...
      Working...
      X