Announcement

Collapse
No announcement yet.

Ball Accelerator not working

Collapse

Adsense Classic 1

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Ball Accelerator not working

    Having a problem with ball accelerator. It will not start when you turn the machines on. I have replaced both relays but still have nothing. If I plug motor into an extension cord, the motor runs fine. Any help would be greatly appreciated.

  • #2
    It sounds like there is no power to the relay box for the relays to switch. You need a meter.

    Comment


    • #3
      The power for your front relays starts in the back. check and see if they work. sometimes the connector on accelerator box gets loose.
      I'm going fishing and camping!

      Comment


      • #4
        The motor won't start with either machine of the pair on? A couple of things to check. First one, are the cannon plugs that supply the 24V for the relays connected to the electrical box? I have disconnected one or both of those before when doing certain maintenance on machines and have forgotten to connect 'em when I finish. The other is to make sure that you're getting voltage to the accelerator motor through the drop cord from the ceiling. That power is usually on a separate circuit from the pinsetters and there should be circuit breakers for the accelerators in one of the distribution panels in the service aisle. As stated above, use a meter to do some of the troubleshooting.
        It is wiser to find out than suppose.--Mark Twain

        Comment


        • #5
          It ended up being a bad breaker on the wall. It was weird because it's the same breaker for the machine and ball accelerator, and the machines were working fine. Thanks for the help.

          Comment

          Adsense Classic 2

          Collapse

          Related Topics

          Collapse

           

          Detector Rod Adjustment

          I am currently doing my first detector rod adjustment. The first thing the book tells you to do is adjust the gap between the oor controller and the blocking surface on the detector...
           

          The New Brunswick NXT

          Best Pinsetter on the market today
           

          Distributor Repair Kit

          Has anyone installed a dist. repair kit ? Wanted to know if its a fix to the problem or just a brunswick brand Band-Aid....
           

          Preventative Maintenance - Brunswick A, Jets, A2 - Wiring Problems

          Had to do a service call at a friend's center as he was out of town. Seems Accelerator on 5 & 6 had quit. Breaker, (which fed 3 pairs), had not tripped, ohm check on motor...
           

          Preventative Maintenance - A Jets A2 - Pinsetter Procedures

          Over the years I've compiled info in a 3-ring binder for quick reference. I decided to add a bunch to it and make one for a few of my friends including the rear-wall house. ...
          Working...
          X