Announcement

Collapse
No announcement yet.

looking for part #

Collapse

Adsense Classic 1

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • looking for part #

    I need the # for the clip
    Attached Files
    Sometimes we have to do stuff to get by....Just go back and do it right when the "by" has passed!!

  • #2
    Re: looking for part #

    167 002 014
    Regards,

    Billy T
    bthompson@qubicaamf.us

    Comment


    • #3
      Re: looking for part #

      That's for the black track. If you have white track, that won't work.
      .
      .
      .
      This post is not an unpaid promotion of my business.

      Comment


      • #4
        Re: looking for part #

        I do have the black track thanks
        Sometimes we have to do stuff to get by....Just go back and do it right when the "by" has passed!!

        Comment

        Adsense Classic 2

        Collapse
         

        Preventative Maintenance - Brunswick All - Bearing Life

        In relation to the recent “B Shaft” failure, I thought I would throw this subject on the table for discussion. I remember when I attended a “Bearing Life” seminar long...
         

        Preventative Maintenance Brunswick A Jets A2 - SC/Dk Pulley Assembly

        Found a bad left needle bearing in the Scissor / Deck Cable Assembly at the Rear Wall House. Needle Bearings are falling out and there is a pile of metal under it. Been 30+...
         

        Preventative Maintenance - Brunswick B-10's Hollar House

        Took a trip back in time to the classic “Hollar House”. The lanes went in in 1908. There was no ABC but according to the current operator, Tom, it became sanctioned when...
         

        Table support assembly

        My night at part job all 32 lanes going of leagues no where to move. Table support assembly broke rod broke # 2 Cell and bent the heck out of wire channel. Changed the Cell,...
         

        Foul Light LED Mod

        Here is a mod I came up with for a foul light unit. I was able to remove the old indicator light bulbs and replace them with ultra bright white LEDs. This should work for about...
        Working...
        X