No announcement yet.

82/70 won't program...


Adsense Classic 1

  • Filter
  • Time
  • Show
Clear All
new posts

  • Ausweegie
    Is the lane in instructomat?

    Leave a comment:

  • mefixalane
    started a topic 82/70 won't program...

    82/70 won't program...

    The pinsetter won't program through the MP chassis..The chassis will program through the pbz.but the pinsetter wont ( only back end motor comes on)..I can run sweep and table through chassis push button switches,also can run sweep through the sweep run switch...Cannot run sweep or table through SA or TA..The chassis and sweep cam switches have been replaced still same issue (pinsetter won't program)...problem solve...Power switch wire from rear control panel shorted out in wireway on its way to 5 and 6 in the A&MC box

Topic Starter RibbonScript


Adsense Classic 2


Related Topics



Distributor Clutch Stop Blade Wear

Replaced this stop blade on an Edge machine at a private installation I service. It looks like this after 20,000 frames. The stop blade on the machine next to it looks new after...

Qubica BES-X Lane Advertising

Anyone know if/how to replace the BES-X "station ID" graphic that shows up before and after a video ad runs on the monitors? I'd much rather have it show our logo, especially...

Ball Damage at my wits end

We have been getting ball damage on a pair of lanes and we are at our wits end trying to find the problem. Every time we think we have found it we get another ball with damage...

GS-X table bolts/stud

I know I'm not the only one who has had the table bolts literally shear off. I cannot explain where there would be a force strong enough to do this to the bolts.
Other that...

Preventative Maintenance - Jet Back Booster & A2 Accelerator Control Boxes

I convert my booster control relays over to Plug-ins as they fail. They are the same as the Motor Start & Recycle relays which makes it very convenient.


Solderless relay conversion

Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...