Announcement

Collapse
No announcement yet.

82/70 ss omega tek

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 82/70 ss omega tek

    1st ball sweep goes to guard, as soon as table moves sweep runs about halfway to headpin and stops.....cam switches appear correct, chassis has been moved....any ideas?

  • #2
    Originally posted by john dubose View Post
    1st ball sweep goes to guard, as soon as table moves sweep runs about halfway to headpin and stops.....cam switches appear correct, chassis has been moved....any ideas?
    Have you swapped out the stator on the sweep motor?

    Comment


    • #3
      That's an interlock John. SC opened at first guard position causing both motors to run at the same time.
      There! Try to NOT work now!

      Comment


      • #4
        Just so everyone knows it was an interlock related problem along with some bad pins and sockets. Thanks for all your help, just an old a2 guy trying to help.

        Comment

        Topic Starter RibbonScript

        Collapse

        Adsense Classic 2

        Collapse

        Related Topics

        Collapse

         

        Super Bowl Funday!

        This is how my day started. The note left by the night mechanic was "The cam needs adjustments. Table keeps going up and down."

        ...
         

        Distributor Clutch Stop Blade Wear

        Replaced this stop blade on an Edge machine at a private installation I service. It looks like this after 20,000 frames. The stop blade on the machine next to it looks new after...
         

        Qubica BES-X Lane Advertising

        Anyone know if/how to replace the BES-X "station ID" graphic that shows up before and after a video ad runs on the monitors? I'd much rather have it show our logo, especially...
         

        Preventative Maintenance - Jet Back Booster & A2 Accelerator Control Boxes

        I convert my booster control relays over to Plug-ins as they fail. They are the same as the Motor Start & Recycle relays which makes it very convenient.

        ...
         

        Making TDM's adjustable.

        I have some machines that the time delay cycles like right now when machine is triggered instead of the 3 sec delay. Would like to put in a potentiameter to correct this. Does...
         

        Solderless relay conversion

        Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...
        Working...
        X