Announcement

Collapse
No announcement yet.

Distributor sticking

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • cabber
    replied
    If you have a waffle-belt the belt is touching the iron tube that holds the distributor sides together.

    Leave a comment:


  • mrpinspotter
    replied
    Search blind hole bearing puller.

    Leave a comment:


  • jeremyb299
    replied
    They all seem to check out ok.
    How in the world would you get the needle bearings out anyway? The one clear at the top? (Or bottom,depending how you're looking at it lol)

    Leave a comment:


  • Ausweegie
    replied
    Check your rollers. They might be a bit tight

    Leave a comment:


  • jeremyb299
    replied
    Quick update
    while distributor is fully extended and at the head pin,I put a little downward pressure near the trip levers I can feel it want to bind when I push it towards the 7 pin side. Bearing going bad at the mount?

    Leave a comment:


  • jeremyb299
    started a topic Distributor sticking

    Distributor sticking

    Other than the clutch, what are some of the top reasons that the distributor would stick at the number 2 bin while going from 2-4?

Topic Starter RibbonScript

Collapse

Adsense Classic 2

Collapse
widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.
 

Preventative Maintenance - A Jets A2 - Elevator & Pits

All this work just to clean under the elevator !!??? LOL A friend is replacing a number of his elevators as the left hand triangle plate brackets are breaking. Rather than...
 

Preventative Maintenance - A Jets A2 - Ball Wheel Belt Question

A friend was looking at his ball wheel belt which stated it was 208" long, (Pic 1). He was pretty sure that it is a B205 belt which should be 205" long. The answer...
 

MONITOR COLOR ISSUE!!

my appologies if Ive posted this in the wrong area, this is my second post on this site, Ive got a 10 lane center ( 5 pairs ) and on lanes 3&4, I am having a problem with...
 

Pin spot is off

I'm currently working at a 38 Lane center. Of those 38 lanes only a few are having this issue.

I'm currently trying to get all the lanes to have perfect pin spots...
 

Idler shaft

One of our lanes has a bad bearing assembly for the distributor pulley. The idler shaft that the pulleys sit on has been damaged where it sits on the bearing. I took the assembly...
Working...
X