Announcement

Collapse
No announcement yet.

Looking for Good Part number

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Looking for Good Part number

    Looking for wedge clips to lock down 7-10 lever and link assembly that locks down shaft.
    walledup10to10 rideing the e.a.c !! you speak whale ??

  • #2
    Is this even a GS thing?

    Comment


    • #3
      looking for wedge clip that goes into lever
      walledup10to10 rideing the e.a.c !! you speak whale ??

      Comment


      • #4
        A photo might help.
        let me be myself

        Comment


        • #5
          Wedge Small GSX
          47-055319-003
          Wedge Large GSX
          47-055320-003

          Comment

          Topic Starter RibbonScript

          Collapse

          Adsense Classic 2

          Collapse

          Related Topics

          Collapse

           

          Super Bowl Funday!

          This is how my day started. The note left by the night mechanic was "The cam needs adjustments. Table keeps going up and down."

          ...
           

          Distributor Clutch Stop Blade Wear

          Replaced this stop blade on an Edge machine at a private installation I service. It looks like this after 20,000 frames. The stop blade on the machine next to it looks new after...
           

          Qubica BES-X Lane Advertising

          Anyone know if/how to replace the BES-X "station ID" graphic that shows up before and after a video ad runs on the monitors? I'd much rather have it show our logo, especially...
           

          Preventative Maintenance - Jet Back Booster & A2 Accelerator Control Boxes

          I convert my booster control relays over to Plug-ins as they fail. They are the same as the Motor Start & Recycle relays which makes it very convenient.

          ...
           

          Making TDM's adjustable.

          I have some machines that the time delay cycles like right now when machine is triggered instead of the 3 sec delay. Would like to put in a potentiameter to correct this. Does...
           

          Solderless relay conversion

          Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...
          Working...
          X