Announcement

Collapse
No announcement yet.

8 pin loads but will not set

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • GG Brunswick GG
    replied
    i have actually tried that already and have actually fix the problem by adjusting the position at pin deck only as referred to in the manual and then the 8 pin was setting everytime thanks for you help anyways!!!

    Leave a comment:


  • A-RON
    replied
    U check the harness with the holders in spotting position or laying down? Sounds like a wire is loosing contact when the holders flip to set
    could also be the table cable loosing contact when it's stretched out when the table goes down

    Leave a comment:


  • GG Brunswick GG
    started a topic 8 pin loads but will not set

    8 pin loads but will not set

    i have a machine that will accept its 8 pin from the pin station but when it goes to set the pin-holder will not set have replaced solenoid micro etc. and i do know that it isn't the wiring harness have just checked it anyone have any ideas?

Topic Starter RibbonScript

Collapse

Adsense Classic 2

Collapse

Related Topics

Collapse

 

Help-broken Part

my crew was clearing a pin jam when the part fell on to the pin-deck. no enough experience to know where this is or what it's called. looking for help so we can order the part...
 

Qubica VDB Battery Replacement Part 2.

Greeting all.
I am sharing a link for a video, part 2, on how I replaced the battery in a Qubica VDB unit.
Thanks for looking.
Bolton454
 

Pin Damage

I have GSX pinsetters just over one year old. Just one of my machines is causing this damage to my pins. I have already adjusted the pin deflector boards to cover the bottom bolts...
 

Making TDM's adjustable.

I have some machines that the time delay cycles like right now when machine is triggered instead of the 3 sec delay. Would like to put in a potentiameter to correct this. Does...
 

1:1 shaft wear

Hi all....I have a pinsetter that knocks over pins at times when setting new pins. The moving deck shifts very abruptly right around 270 degrees. Instead of a smooth movement,...
Working...
X