Announcement

Collapse
No announcement yet.

How to stop candlepin pinsitters from setting up less than ten pins.

Collapse

Adsense Classic 1

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • How to stop candlepin pinsitters from setting up less than ten pins.

    Hi, I work on candlepin pinsitters by bowlmor, and now found a way to stop it from setting up odd number of pins and not to over tighten the lift chain also, which also reduces drage on the v-belt.
    This will alow the system to only set 10 pins, the pusher deck only works if all three switches are closed.

Adsense Classic 2

Collapse
 

Preventative Maintenance - Brunswick All - Bearing Life

In relation to the recent “B Shaft” failure, I thought I would throw this subject on the table for discussion. I remember when I attended a “Bearing Life” seminar long...
 

Preventative Maintenance Brunswick A Jets A2 - SC/Dk Pulley Assembly

Found a bad left needle bearing in the Scissor / Deck Cable Assembly at the Rear Wall House. Needle Bearings are falling out and there is a pile of metal under it. Been 30+...
 

Preventative Maintenance - Brunswick B-10's Hollar House

Took a trip back in time to the classic “Hollar House”. The lanes went in in 1908. There was no ABC but according to the current operator, Tom, it became sanctioned when...
 

Table support assembly

My night at part job all 32 lanes going of leagues no where to move. Table support assembly broke rod broke # 2 Cell and bent the heck out of wire channel. Changed the Cell,...
 

Foul Light LED Mod

Here is a mod I came up with for a foul light unit. I was able to remove the old indicator light bulbs and replace them with ultra bright white LEDs. This should work for about...
Working...
X