If you are seeing this you are not logged in to Bowl-Tech. Remove this notice by Registering or Logging in
By your continued use of this site you are agreeing to the following.
You are over the age of 18, have had supervised training in safety and operations for the equipment you work on. Bowl-Tech does not warrant or guarantee the accuracy of information found on this site. Bowl-Tech, its officers and site Admins, Mentors and Guides will not be responsible in the case of losses financial or otherwise as a result of use of ANY information on this site. Posts on this site are allowed by registered members and each registered member is responsible for the content of their posts.
If you can not agree to any of these terms of use above or are not at least 18 years of age you are asked NOT to visit Bowl-Tech or utilize its content. To visit the Bowl-Tech Terms of Service and Rules CLICK HERE
Beautiful.
Not only do I like how the store made this pinsetter a 'centre piece' but they're also using other furniture such as old ball return racks as ball displays.
Hi folks, the Pinsetter/Pinspotter forum had was doing so well I figured it was time to break it up into two forums, this should help cut down on any confusion by organizing things...
Replaced this stop blade on an Edge machine at a private installation I service. It looks like this after 20,000 frames. The stop blade on the machine next to it looks new after...
Anyone know if/how to replace the BES-X "station ID" graphic that shows up before and after a video ad runs on the monitors? I'd much rather have it show our logo, especially...
We have been getting ball damage on a pair of lanes and we are at our wits end trying to find the problem. Every time we think we have found it we get another ball with damage...
I know I'm not the only one who has had the table bolts literally shear off. I cannot explain where there would be a force strong enough to do this to the bolts.
Other that...
I convert my booster control relays over to Plug-ins as they fail. They are the same as the Motor Start & Recycle relays which makes it very convenient.
Hi all....I have a pinsetter that knocks over pins at times when setting new pins. The moving deck shifts very abruptly right around 270 degrees. Instead of a smooth movement,...
Working...
X
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment