Announcement

Collapse
No announcement yet.

What caused this

Collapse

Adsense Classic 1

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Headpin
    started a topic What caused this

    What caused this

    20180603_151639.jpg20180603_151602.jpg

  • zbowl
    replied
    aliens that use brunswick gray

    Leave a comment:


  • billman
    replied

    Leave a comment:


  • loadtoad
    replied
    Yeah, I'm clickin' aliens too .... makes sense to me.

    Leave a comment:


  • Headpin
    replied
    Originally posted by billman View Post
    I think you have found the answer. That was my second thought. And Aliens was my first lol
    Fixed,.........onya Bill

    Leave a comment:


  • billman
    replied
    I think you have found the answer. That was my first thought. And Aliens was a close second! lol

    Leave a comment:


  • Headpin
    replied
    Close but no dice Mike. I'm guessing it's caused by the projection on the pin that secures the roller to the clutch lever. The clutch lever was so badly adjusted and ignored that the lever lowered far enough to contact the clutch release lever.

    The wear mark is consistent with the roundness of the projection pin and correspondes with that side of the release lever.

    Anyone else have a better scenario? Besides Aliens.......which would have been my second guess.

    Leave a comment:


  • Headpin
    replied
    Yes. Every lever has similar marks. It's not a manufacturering fault.

    Leave a comment:


  • mickeygm
    replied
    First guess... Aliens, definitely Aliens Second guess... Someone took a can of gray spray and painted it...LOL Seriously, I'm guessing from the pic this is the clutch release lever ? I would have said a casting flaw but the wear patterns are similar But different. Not a clue Are all the machines like this? Would have had to been a ton of shavings while this was going on??

    Leave a comment:

Adsense Classic 2

Collapse
 

The New Brunswick NXT

Best Pinsetter on the market today
 

Distributor Repair Kit

Has anyone installed a dist. repair kit ? Wanted to know if its a fix to the problem or just a brunswick brand Band-Aid....
 

Preventative Maintenance - Brunswick A, Jets, A2 - Wiring Problems

Had to do a service call at a friend's center as he was out of town. Seems Accelerator on 5 & 6 had quit. Breaker, (which fed 3 pairs), had not tripped, ohm check on motor...
 

Preventative Maintenance - A Jets A2 - Pinsetter Procedures

Over the years I've compiled info in a 3-ring binder for quick reference. I decided to add a bunch to it and make one for a few of my friends including the rear-wall house. ...
 

Transformer Installation Instructions

Does anyone have the installation instructions for P/N: 12-862164-000 ?
Working...
X