Announcement

Collapse
No announcement yet.

Electronic trigger board

Collapse

Adsense Classic 1

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Electronic trigger board

    Can anyone tell me how to rewire an electronic trigger board to change to a tdm? Or where I can buy some more electronic trigger boards. Thanks in advance.

  • #2
    http://www.bowltech.com/forum/pinset...ay-module-help
    Factory & Converted A-2 (US, Ger, Jap)
    Comscore ECT, Matrix & DuoHD
    Walker B, Sanction Standard, Original K, Flex Walker & Ikon
    Kegel C.A.T.S

    Comment


    • #3
      Thanks Kanga but I need to go from board to module.

      Comment


      • #4
        No difference. The terminal configuration should be no different. You just don't connect the sensors.
        Factory & Converted A-2 (US, Ger, Jap)
        Comscore ECT, Matrix & DuoHD
        Walker B, Sanction Standard, Original K, Flex Walker & Ikon
        Kegel C.A.T.S

        Comment

        Adsense Classic 2

        Collapse

        Related Topics

        Collapse

         

        Preventative Maintenance Brunswick A Jets A2 - Pin Light Conversion

        Rear Wall House was having a big problem with the pin lights. The ends were pretty much worn out from the vibration so duct tape, electrical tape and jiggling the light would...
         

        Detector Rod Adjustment

        I am currently doing my first detector rod adjustment. The first thing the book tells you to do is adjust the gap between the oor controller and the blocking surface on the detector...
         

        The New Brunswick NXT

        Best Pinsetter on the market today
         

        Distributor Repair Kit

        Has anyone installed a dist. repair kit ? Wanted to know if its a fix to the problem or just a brunswick brand Band-Aid....
         

        Preventative Maintenance - Brunswick A, Jets, A2 - Wiring Problems

        Had to do a service call at a friend's center as he was out of town. Seems Accelerator on 5 & 6 had quit. Breaker, (which fed 3 pairs), had not tripped, ohm check on motor...
        Working...
        X