Announcement

Collapse
No announcement yet.

82-30 table reconfiguration for Qscore

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • exMech
    replied
    Here is the pinout for the JP9 connector (in red box in previous pic) on the Q vision camera board. The corresponding connections are for the MP chassis so that may vary depending on what chassis you are using.

    You expander board should show the connections for it or post which expander you are using.
    Attached Files

    Leave a comment:


  • exMech
    replied
    Here is the board overview for the Q vision camera. You will connect your expander boards to the connector boxed in red. You have 6 connections here, 3 for the odd lane and 3 for the even lane.
    Attached Files

    Leave a comment:


  • Roy L. Kimes
    replied
    Q vision

    Leave a comment:


  • exMech
    replied
    If you have Qscore with Q vision camera then you can simply wire the camera into the expander card on your chassis. Which chassis are you using? Does your scoring use the Q vision camera or the T vision?

    Leave a comment:


  • chuck127
    replied
    Check your PM

    Leave a comment:


  • Roy L. Kimes
    replied
    I have the expander boards but don't know how to hook them to the scoring system. Over the years the previous owner cut the wires on the re spot cells and added a button to reset the pins.

    Leave a comment:


  • chuck127
    replied
    If you added scoring there is no reason not to have a strike cycle unless the installer removed wires j-26 ,& j-27 this is the K&L circuit going to the respot cells check to make sure they didn't remove the wires also check all of the switches on the respot cell for a broken wire there is another way around this if you have omega tec mk30s you can add a expander card and tie it into the scoring for a short strike cycle the table will never move on 1st ball if it's a strike it clear the deck and spots a new set of pins

    Leave a comment:


  • Roy L. Kimes
    started a topic 82-30 table reconfiguration for Qscore

    82-30 table reconfiguration for Qscore

    Recently updated to automatic scoring from original paper scoring. Q score from AMF reads strikes but does not cycle a new set of pins. Was told there might be a re-wiring needed. any one know how?

Topic Starter RibbonScript

Collapse

Adsense Classic 2

Collapse

Related Topics

Collapse

 

Streamlane Mask Halo Lights

With huge thanks to "Toby" for all his help & expertise...my old masks now have for-real halo lights again.


...
 

Baddest Tool Chest In Town

Adios, motor boater!

...
 

Aluminum Repair and Welding

with our broken moving deck i have been asked to figure out if there is a way we can weld it back together in house for very little expense.
http://aluminumrepair.com/...
 

Setting Table Harness Connections

Hi, guys.

We recently replaced our setting table harness and when the machine's run in diagnostic mode, we get 01, 02, 03, 04 + 09 errors, or when you place pins...
 

check this jam...

the ball stuck the table up

...
Working...
X