No announcement yet.

Accuscore wiring


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • Accuscore wiring


    AccuScore+, 82-70's SS chassis.

    There is a wire going to the b/e control box being piggy backed on the table contactor switch.. comes from same cable for the cycle switch.

    Anyone know what it is or whats its for?

  • #2
    Enables respot only pins without scoring,which is part of the wiring on SS chassis


    • #3
      Actually, it is the power 'on' wire. Turnkey mentions the other pair, which is hooked to the cycle button for "RPO". The red wire on the sweep/table common wire tells the scoring the pinspotter is on. This voltage is also used for the start signal when the sweep drops. So, you should have 24 volts on the start switch when ther sweep is up, and the machine is on. That voltage goes away when the machine is turned off (also when the sweep drops on cycle).
      This post is not an unpaid promotion of my business.


      Topic Starter RibbonScript


      Adsense Classic 2

      widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

      MP Chassis Tester

      Good morning,
      I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
      I am using relays. My question is to anyone that may...

      Preventative Maintenance - As, Jets, A2s - LEDs

      Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

      4:1 Timing off..

      *sigh* Hello friends..

      I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

      Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

      Left a rant about this in the bowling forum…

      I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

      Turret clutch rebuild

      At what thickness do you replace the clutch face.
      Is there a minimum dimension from the clutch face to the rivet.


      Solderless relay conversion

      Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...