No announcement yet.

Calibration Issues


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • Calibration Issues

    I have Accuscore Model 7500 on my lanes. I am new to the bowling bussiness and the previous owners left nada for documentation. I've been told you need to calibrate them every so often to keep them scoring correctly. Does anyone out there have any liturature they could scan and email to me explaining how to do the calibration? Our email is [email protected]


  • #2


    • #3
      Thanks for the replys and emails. An owner not far from me has the documentation I am looking for and I am going to get it this weekend.


      • #4
        a word of advice if they are scoring fine, dont touch them! if you start getting phantom pins or strikes then adjust them. I have some cameras I havent touched in 10 years. oh boy, I'll have scoring issues tomorrow after saying that


        Topic Starter RibbonScript


        Adsense Classic 2

        widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

        MP Chassis Tester

        Good morning,
        I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
        I am using relays. My question is to anyone that may...

        Preventative Maintenance - As, Jets, A2s - LEDs

        Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

        4:1 Timing off..

        *sigh* Hello friends..

        I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

        Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

        Left a rant about this in the bowling forum…

        I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

        Turret clutch rebuild

        At what thickness do you replace the clutch face.
        Is there a minimum dimension from the clutch face to the rivet.


        Solderless relay conversion

        Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...