No announcement yet.

Touch Desk 3? Anyone? Feedback would be awesome...


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • Touch Desk 3? Anyone? Feedback would be awesome...

    Our POS and lane control system fried. We are set up to get a new system and was wondering if any of you folks are using touch desk 3...

  • #2
    We are currently using Touch Desk 3. I have to say the system has worked wonderfully for us. We have had it installed since August and it has been great. We have 56 lanes and the management system has had no problems keeping up with the demands the large center has put on it. The integration with our Accuscore XL was very seamless and has enhanced the user experience at the front desk and in the back office. The ability to use CDE software to manage leagues and tournaments has been a real plus for us. Also, the support provided has been great. From my experience with Touch Desk 3 I would recommend to anyone looking to upgrade POS and back office systems.


    Topic Starter RibbonScript


    Adsense Classic 2

    widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

    MP Chassis Tester

    Good morning,
    I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
    I am using relays. My question is to anyone that may...

    Preventative Maintenance - As, Jets, A2s - LEDs

    Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

    4:1 Timing off..

    *sigh* Hello friends..

    I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

    Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

    Left a rant about this in the bowling forum…

    I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

    Turret clutch rebuild

    At what thickness do you replace the clutch face.
    Is there a minimum dimension from the clutch face to the rivet.


    Solderless relay conversion

    Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...