No announcement yet.

Lanes not communicating with Front Desk


Adsense Classic 1

  • Filter
  • Time
  • Show
Clear All
new posts

  • marc
    we've had that problem here along with pinsetters to flicker on and off while cycling. we also played hell to find the problem and went thru all the things you have done. what we have found is the RJ45 patch panel was to blame. also check all the plugs and make sure all the wires are completely in their sockets, found that problem a few times also.

    Leave a comment:

  • Lanes not communicating with Front Desk

    So to start I had one pair of lanes not communicating with the front desk. I've switched the hard drive and the i/o board with another pair and they work fine. Then the other day I tried a new ethernet cable back to the hub and still didn't work so I tried the new cable on another pair just to make sure that it worked and now that pair is also not communicating even when plugging it back into the original cable. Tried again on another pair and same thing that quit communicating. So now I'm lost as to what to try next. All three pair we have are not in communication now. Any suggestions? Frameworx scorers

Topic Starter RibbonScript


Adsense Classic 2

widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

Well this is a first.

We all from time to time have one of those “wow I’ve never seen THAT before” moments. Well today was one of those for me when my night tech texts me to say lane 16 is out...

Ball return wheel guide roller removal.

Hey guys, i could just use a bit of advice trying to get this part out, first time I've had to do one of these. I got it to move a few turns but its come to a point where it has...

Even old mechanics find something new.

All my years working on these things I never had this happen…… until last week. ...

82-90XL Frontend Gearbox Parts - Rebuild Woes

We have 5 of the 088000365 replacement gear kits on the shelf, and I pulled two gearboxes off machines earlier this week, so I thought I'd try my hand at rebuilding them and save...

Prolane damage

Can this be repaired?

LED Ball Lights

Made an LED conversion for A2's and Frameworx masks. It can also be modded for the Harmony masks to accept 2 x 5mm led's and/or a 12v supply. Once I'm happy with the performance/design...