Announcement

Collapse
No announcement yet.

Frameworx FlatScreen Consoles

Collapse

Adsense Classic 1

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Frameworx FlatScreen Consoles

    Have a sister center that has the flatscreen setup on the settees. They are having an issue where the screen is way out of calibration. They have moved eveything that they can think of. They even swapped flatscreens with another lane and the problem stayed. Now, I don't know too much about this setup (I have keypads), so please explain clearly so I can relay any information that you provide.

    Thanks,

    JOEY
    Tags: None
  • #2
    Have they tried swapping or reloading the LGP hard drive?
    "Party on dude!"

    Comment

    • #3
      Talked to him last night. That was next on the list. I'll let you know the result when I hear from him the next time.

      Joey

      Comment

      • #4
        Update....The hard drive was replaced and seems to have fixed the issue.

        Thanks again.

        Comment

        • #5
          No worries, thanks for letting us know!
          "Party on dude!"

          Comment

          Previous template Next

          Topic Starter RibbonScript

          Collapse

          Adsense Classic 2

          Collapse

          Related Topics

          Collapse
           

          A2 1 to 1 Gear Box Cover Replacement Due to Crack

          I am refurbishing two converted A2 machines that I will be installing in my home basement this fall. One of them has a leaking gear box and cracked 1:1 gear box cover. I have...
           

          Streamlane Mask Halo Lights

          With huge thanks to "Toby" for all his help & expertise...my old masks now have for-real halo lights again.


          ...
           

          Baddest Tool Chest In Town

          Adios, motor boater!

          ...
           

          Aluminum Repair and Welding

          with our broken moving deck i have been asked to figure out if there is a way we can weld it back together in house for very little expense.
          http://aluminumrepair.com/...
           

          Setting Table Harness Connections

          Hi, guys.

          We recently replaced our setting table harness and when the machine's run in diagnostic mode, we get 01, 02, 03, 04 + 09 errors, or when you place pins...
           

          check this jam...

          the ball stuck the table up

          ...
          Working...
          X