Announcement

Collapse
No announcement yet.

Scoring Foul When It Shouldn't

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Stripperbolt
    replied
    Had this same thing last year. Unplugged the foul cables from the foul unit up front and it still scored "F". For a temp solution 'til I had time to dig into it, I unplugged the foul connector at the CCD processor board. Found the issue a couple of days later: the cable had gotten pinched between a filler board and the wood kickback underneath the dropsweep track and had worn through the wires insulation and they were shorting out.

    Leave a comment:


  • MASTERMIKE
    replied
    Check as stated above,

    Could also be your processor box

    Mike

    Leave a comment:


  • jim_long
    replied
    Check your under ground cables from the pinsetter to the foul light, probably got ran over and shorted to ground.

    Else, unplug from foul light(foul cable) and see if it goes away. If so, then the foul light is at fault.

    Leave a comment:


  • JamesP
    started a topic Scoring Foul When It Shouldn't

    Scoring Foul When It Shouldn't

    We are having an issue with a lane that is scoring a "Foul" even when the Foul Lights are turned "off". It acts exactly like we are fouling but we are not, sweeps the spare and all. Frameworks scoring. Any ideas?

Topic Starter RibbonScript

Collapse

Adsense Classic 2

Collapse
widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.
 

Rake sweeping out of time, and pin launching onto lane.

I work on some nice old Brunswick A-2 pin setters. Most issues I've come across haven't been to problematic to figure out. But being I can't seem to get it to recreate the issue...
 

Strange sweep problem

I’m a rookie mechanic and have been working on pinsetters for 2 years. One of my lanes has a problem with a sweep possibly coasting. I don’t know what could be causing it...
 

GSX Distributor shaft bearings

Two part topic:
1. Plastic bearing (#66) used in place of regular sealed bearing (#51) -- thoughts?

2. ANY of these bearings with the black support mount...
 

The Legacy of the A2

I was recently disheartened to learn that a bowling center that I once serviced was actively looking to replace their A2's. I understand that most military bases and educational...
 

Table turning on short stroke.

Hello dear Bowltech members.
First let me say thank you for your time. am plagued by a big issue for three weeks now.
our technician is working full time on another...
 

Another pivot bearing broke.

One and a half year old GSX machines. This will be the 5th pivot bearing that has broke. This one decided to take out a few things with it. Snapped the stroke limiter shock stud...
Working...
X