No announcement yet.

This maybe somthing to check on your Framworx system


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • This maybe somthing to check on your Framworx system

    Hey Guys,
    Was having some problems with secondary console breakers popping every time someone would bowl on certain pairs.
    This would knock out power to the secondary console, the interface, and the CCD.

    Turns out when brunswick ran the MC cables they routed the cables to close to the accelerator motor.
    This eventuality wore right through the MC and shorted out the wires against the motor.

    So if you have an older Frameworx installation this maybe something for you to check.
    Every 3-4 pair there should be 3 MC cables dropping from the ceiling by the accelerator make sure they are routed away from the motor and anything else thet can where through the MC.

    Hope this helps someone.

    Go with what works and not what the book says.

Topic Starter RibbonScript


Adsense Classic 2

widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

MP Chassis Tester

Good morning,
I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
I am using relays. My question is to anyone that may...

Preventative Maintenance - As, Jets, A2s - LEDs

Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

4:1 Timing off..

*sigh* Hello friends..

I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

Left a rant about this in the bowling forum…

I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

Turret clutch rebuild

At what thickness do you replace the clutch face.
Is there a minimum dimension from the clutch face to the rivet.


Solderless relay conversion

Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...