Announcement

Collapse
No announcement yet.

Global video

Collapse

Adsense Classic 1

Collapse

TOTY

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Global video

    I'm currently having some problems with the monitor on one lane switching to global video. This only happens during league or open play. Doesn't seem to do it while the commercials are scrolling. If I reboot the scoring it doesn't seem to work, however if I shut the system down for a few minutes it makes the problem go away for a few weeks. I've tried switching the monitor cables in the back from one lane to another and the problem will switch to the other lane. Could this be a bad motherboard? Any suggestions are greatly appreciated. Thanks!

  • #2
    I would quicker think a bad port on the video board if as you state the problem moves when you switch the cables around.
    You don't have to be crazy to do this job...But it helps!

    Comment

    Topic Starter RibbonScript

    Collapse

    Adsense Classic 2

    Collapse
    widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.
     

    MP Chassis Tester

    Good morning,
    I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
    I am using relays. My question is to anyone that may...
     

    Preventative Maintenance - As, Jets, A2s - LEDs

    Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

    www.ledsupply.com...
     

    4:1 Timing off..

    *sigh* Hello friends..

    I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....
     

    Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

    Left a rant about this in the bowling forum…

    I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....
     

    Turret clutch rebuild

    At what thickness do you replace the clutch face.
    Is there a minimum dimension from the clutch face to the rivet.

    Thanks...
     

    Solderless relay conversion

    Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...
    Working...
    X