Announcement

Collapse
No announcement yet.

90s cameras

Collapse

Adsense Classic 1

Collapse

TOTY

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 90s cameras

    We just purchased cameras to replace 86 scanners and we need to know what cables we need to buy to install the cameras?
    Also is there any instructions to show us how to install them and to adjust the cameras.

    Thanks Ron

  • #2
    The lane cables that stopped at the camera will have to be replaced to now reach the CCD box. And that underlane to the console now is the power for the CCD- comes from the console now, not machine power as the scanner did.
    The actual machine cable from the NPS can be plugged into the CCD box as the connector and signals are the same. But you will disconnect the green wire on the TS, if it's connected now.
    There will be 3 cables to the camera from the CCD box. 2 coaxes and power.
    The foul pick-up is the same on the foul unit side, but needs to reach the CCD box. It's too short the way it is.
    .
    .
    .
    This post is not an unpaid promotion of my business.

    Comment

    Topic Starter RibbonScript

    Collapse

    Adsense Classic 2

    Collapse
    widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.
     

    MP Chassis Tester

    Good morning,
    I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
    I am using relays. My question is to anyone that may...
     

    Preventative Maintenance - As, Jets, A2s - LEDs

    Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

    www.ledsupply.com...
     

    4:1 Timing off..

    *sigh* Hello friends..

    I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....
     

    Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

    Left a rant about this in the bowling forum…

    I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....
     

    Turret clutch rebuild

    At what thickness do you replace the clutch face.
    Is there a minimum dimension from the clutch face to the rivet.

    Thanks...
     

    Solderless relay conversion

    Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...
    Working...
    X