No announcement yet.

not scoring


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • not scoring

    hi guys,i have only just returned to the bowling game after being away for 4 years and did`nt think i would be back,anyhow i i have a gs g6 with qubica scoring and the machine refuses to score,on the qubica interface its keeps say its on the 2nd cycle but refuse to change,any idea would be very appreciated as i am very rusty in this game now,cheers kev.
    if in doubt,then give it a clout.

  • #2
    It appears that the pinsetter is sending a second ball signal to the scoring all the time. You can go to front desk > setup > technical setup > pinsetter and camera and uncheck the second lamp box to make the scoring ignore the second ball signal until you find the reason the pinsetter is giving a second ball signal all the time. After you repair or adjust the pinsetter you should check that second lamp box again.


    Topic Starter RibbonScript


    Adsense Classic 2

    widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

    MP Chassis Tester

    Good morning,
    I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
    I am using relays. My question is to anyone that may...

    Preventative Maintenance - As, Jets, A2s - LEDs

    Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

    4:1 Timing off..

    *sigh* Hello friends..

    I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

    Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

    Left a rant about this in the bowling forum…

    I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

    Turret clutch rebuild

    At what thickness do you replace the clutch face.
    Is there a minimum dimension from the clutch face to the rivet.


    Solderless relay conversion

    Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...