No announcement yet.

GSX and Qubica


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • GSX and Qubica

    Anyone have this system with the GSX machines? Does it still use the switches on the pin holder or the camera for scoring? How hard would it be to install in house? I have Frameworx now and have very few problems with it, what would be the pros and cons of changing from Frameworx to Qubica?

    For Sale, Parachute. Only used once, never opened, small stain.

  • #2
    Good combo, yes the switches will stay the machine also needs them and it can be intelligent connected so no camera needed.


    • #3
      I just installed BES on GSX. Does use pin detection switches, so you set it for double detect. The setting for the scoring is Frameworks, not AS90. QAMF also terminates the out comm port, but is not necessary. Also interfaces nicely with the pinball wizard controller - set each box for lanes 1/2.
      This post is not an unpaid promotion of my business.


      Topic Starter RibbonScript


      Adsense Classic 2

      widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

      MP Chassis Tester

      Good morning,
      I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
      I am using relays. My question is to anyone that may...

      Preventative Maintenance - As, Jets, A2s - LEDs

      Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

      4:1 Timing off..

      *sigh* Hello friends..

      I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

      Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

      Left a rant about this in the bowling forum…

      I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

      Turret clutch rebuild

      At what thickness do you replace the clutch face.
      Is there a minimum dimension from the clutch face to the rivet.


      Solderless relay conversion

      Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...