No announcement yet.

Premio Computer Issues


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • Premio Computer Issues

    I was in the process of closing the shift in conqueror and the mouse quit working so I tried to reboot the computer and the lights came on on the computer and the monitor came up "no signal". Does anyone have any ideas??!!

  • #2
    Try unplugging the mouse and see if it will boot...
    TSM & TSM Training Development
    Main Event Entertainment
    480-620-6758 for help or information


    • #3
      Check your VGA cable. It's either loosely connected or been disconnected at the CPU or at the monitor cable terminal. A disconnected vga monitor cable will register "no signal" for sure. Your mouse works but the mouse pointer cannot be seen with the disconnected vga monitor cable.
      Last edited by qubica54; 11-06-2012, 08:45 AM.


      • #4
        I found 3 bad capacitors on the mother board. Got new ones from Newark Electronics and soldered them in an all is running well.


        Topic Starter RibbonScript


        Adsense Classic 2

        widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

        MP Chassis Tester

        Good morning,
        I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
        I am using relays. My question is to anyone that may...

        Preventative Maintenance - As, Jets, A2s - LEDs

        Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

        4:1 Timing off..

        *sigh* Hello friends..

        I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

        Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

        Left a rant about this in the bowling forum…

        I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

        Turret clutch rebuild

        At what thickness do you replace the clutch face.
        Is there a minimum dimension from the clutch face to the rivet.


        Solderless relay conversion

        Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...