Announcement

Collapse
No announcement yet.

getting a lot of re-spots

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • getting a lot of re-spots

    for the past few weeks i have been getting A LOT of re-spot calls. had 25 last night. normally its around 12 though. Calibrate the steltronic cameras but it doesn't seem to help. Any ideas anyone?

  • #2
    Are the pins sliding?

    Comment


    • #3
      Originally posted by ccbcgreg View Post
      for the past few weeks i have been getting A LOT of re-spot calls. had 25 last night. normally its around 12 though. Calibrate the steltronic cameras but it doesn't seem to help. Any ideas anyone?
      Could you provide more detail on the types of calls you are getting? Does the problem happen on the same machines or all over the place?
      82-70 MP Pinsetters+Humpback/Light Ball Clutch/Rocket Rails
      *Monitor repair for Steltronic Elex/SuperElex system! Send me PM!

      Comment

      Topic Starter RibbonScript

      Collapse

      Adsense Classic 2

      Collapse

      Related Topics

      Collapse

       

      Streamlane Mask Halo Lights

      With huge thanks to "Toby" for all his help & expertise...my old masks now have for-real halo lights again.


      ...
       

      Baddest Tool Chest In Town

      Adios, motor boater!

      ...
       

      Aluminum Repair and Welding

      with our broken moving deck i have been asked to figure out if there is a way we can weld it back together in house for very little expense.
      http://aluminumrepair.com/...
       

      Setting Table Harness Connections

      Hi, guys.

      We recently replaced our setting table harness and when the machine's run in diagnostic mode, we get 01, 02, 03, 04 + 09 errors, or when you place pins...
       

      check this jam...

      the ball stuck the table up

      ...
      Working...
      X