No announcement yet.

Kustodian LDS Question


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • Kustodian LDS Question

    Just how loose is the chain supposed to be? Ours looks like we could remove a link and it would be fine. This question stems from the fact that on the return when it gets to the foul line it does not stop in the same place every time. Normal?

    I'd hate to think we got a sensor going insane.

    Thanks in advance.

    Necessity IS NOT the mother of invention. Laziness IS the mother of invention.

  • #2
    have you been cleaning your momentary wheels thoroughly? if you have and the machine isn't slipping then go down and watch how far the machine is traveling forward. If the LDS is on the way out logic dictates, you would have inconsistent forward subtract distances too.
    When you know what to do, everything is easy.


    • #3
      The chain is normally quite loose, along as your travel distances are consistent; I wouldn't worry about it.
      The 45/70 Goverment is the only Goverment I trust


      • #4
        Thanks Fellows! I'll double check my forward and reverse distances. The loose chain caught my eye as a problem, but then it isn't under a load, so loose makes sense. I just don't want to have to pull this monster out of a pit. 8o)
        Necessity IS NOT the mother of invention. Laziness IS the mother of invention.


        Topic Starter RibbonScript


        Adsense Classic 2

        widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

        MP Chassis Tester

        Good morning,
        I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
        I am using relays. My question is to anyone that may...

        Preventative Maintenance - As, Jets, A2s - LEDs

        Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

        4:1 Timing off..

        *sigh* Hello friends..

        I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

        Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

        Left a rant about this in the bowling forum…

        I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

        Turret clutch rebuild

        At what thickness do you replace the clutch face.
        Is there a minimum dimension from the clutch face to the rivet.


        Solderless relay conversion

        Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...