No announcement yet.

7 pins !!!!


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • 7 pins !!!!

    not sure if im in the right thread but , my question is ive noticed a lot more 7 pins being left now than ever before ... last night we had 4 ten pins with 10 guys on the pair but my team mate left 4 seven pins just by himself plus i left 3 of them ...what is the cause for leaving soooooo many 7 pins ....pattern / kickbacks / flat gutters ??? also these are being left by right handed bowlers not lefties , they carry just fine !!!!

  • #2
    I have seen when the pins get spongy on the sides the energy gets lost and the pins tend to leave oppisite corners. (righty-7's and lefty-10's) they do leave less regular corners so it averages out, just alittle differnt.


    • #3
      We had the same problem but we started cleaning the pindecks & kickbacks by hand and then hit them with a coat of Brunswick friction. Works wonders for us….


      Topic Starter RibbonScript


      Adsense Classic 2

      widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

      MP Chassis Tester

      Good morning,
      I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
      I am using relays. My question is to anyone that may...

      Preventative Maintenance - As, Jets, A2s - LEDs

      Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

      4:1 Timing off..

      *sigh* Hello friends..

      I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

      Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

      Left a rant about this in the bowling forum…

      I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

      Turret clutch rebuild

      At what thickness do you replace the clutch face.
      Is there a minimum dimension from the clutch face to the rivet.


      Solderless relay conversion

      Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...