No announcement yet.

applying basecoat and topcoat to wood lanes


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • applying basecoat and topcoat to wood lanes

    i have stripped all my lanes down to the bare wood wich i have never done before i have screened and coated them quite a few times but this is firat time i have completely stripped them down to bare wood ! i was wondering if i should use a sealer before i pull my astrolane 100 basecoat on lanes or if the astrolane 100 basecoat will be a sufficient sealer ?

  • #2
    Bushy, I cannot speak for Brunswick lane finish. But our 100% solids base can be applied over "stain" a/k/a sealer. 100% solids base will seal the lane, that's what we used before stain became popular. In my opinion apply stain, 100% solids base, then a good top coat. That's the best finish system going today.
    Cliff Adair
    Director - Aftermarket, QubicaAMF Worldwide


    • #3
      Sorry, I mispelled your name. :-)
      Cliff Adair
      Director - Aftermarket, QubicaAMF Worldwide


      Topic Starter RibbonScript


      Adsense Classic 2

      widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

      MP Chassis Tester

      Good morning,
      I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
      I am using relays. My question is to anyone that may...

      Preventative Maintenance - As, Jets, A2s - LEDs

      Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

      4:1 Timing off..

      *sigh* Hello friends..

      I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

      Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

      Left a rant about this in the bowling forum…

      I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

      Turret clutch rebuild

      At what thickness do you replace the clutch face.
      Is there a minimum dimension from the clutch face to the rivet.


      Solderless relay conversion

      Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...