Announcement

Collapse
No announcement yet.

seriously o-o-d pins

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • seriously o-o-d pins

    Just thought I would see what people had to think of this.

    Our centre is using the amflite II bowling pin. Our current set has been in use since Aug 2008!! We originally had enough to swap all 30 lanes each month but more and more began to develop dead spots. As a department we have decided that the only way to keep enough pins for all 30 lanes is to replace old and worn pins as an when is necessary.

    We began buying in boxes each month and managed to get enough for 6 lanes worth. We havent started using them as we dont really see the point in only 1/5 of the lanes having new pins.

    Has anyone else had to deal with anything this ridiculous? We are a bowling centre, we need pins for people to bowl at!

  • #2
    Put all the new ones in an area that has the least amount of league for a couple month (if possible) then you have the rest for spares. The new ones mixed in with old ones is no good.

    Comment


    • #3
      Buy one box of Twisters per month...they last years.....and are better than broken wood pins

      Comment


      • #4
        Are they Jerry?

        Comment

        Adsense Classic 2

        Collapse
         

        A2 1 to 1 Gear Box Cover Replacement Due to Crack

        I am refurbishing two converted A2 machines that I will be installing in my home basement this fall. One of them has a leaking gear box and cracked 1:1 gear box cover. I have...
         

        Streamlane Mask Halo Lights

        With huge thanks to "Toby" for all his help & expertise...my old masks now have for-real halo lights again.


        ...
         

        Baddest Tool Chest In Town

        Adios, motor boater!

        ...
         

        Aluminum Repair and Welding

        with our broken moving deck i have been asked to figure out if there is a way we can weld it back together in house for very little expense.
        http://aluminumrepair.com/...
         

        Setting Table Harness Connections

        Hi, guys.

        We recently replaced our setting table harness and when the machine's run in diagnostic mode, we get 01, 02, 03, 04 + 09 errors, or when you place pins...
        Working...
        X