Announcement

Collapse
No announcement yet.

Brunswick red crown-- age?

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Brunswick red crown-- age?

    i have a brunswick red crown abc permit no. 5. im looking to find out how old this pin is. ive had it for about 20 yrs.

    I also have 2 wood duckpins, one is a never used brunswick Dura-king wood plastic coated red crown duckpin, the other is a strike master.


    im looking for an appoximate age for this pins. thanks for any help.

  • #2
    O the Brunswick red crown pin what logo is on the front? If the logo is the Brunswick B then it was made in the early 80's If it has a crown for the logo then it would have been made in the late 70's around the same time that the mixer came out.

    Comment


    • #3
      Here's a red crown from 1938, is that what you have?
      http://www.relique.com/vintage-1939-...g-bowling-pin/
      Or this one?
      http://www.ebay.com/itm/Vintage-Brun...item5649503f9c
      I'm going fishing and camping!

      Comment


      • #4
        pj its the second one

        Comment


        • #5
          That would be from the late 70's to early 80's. Your pin is between 30-35 years old.

          Comment


          • #6
            thanks guys

            Comment

            Adsense Classic 2

            Collapse
             

            A2 1 to 1 Gear Box Cover Replacement Due to Crack

            I am refurbishing two converted A2 machines that I will be installing in my home basement this fall. One of them has a leaking gear box and cracked 1:1 gear box cover. I have...
             

            Streamlane Mask Halo Lights

            With huge thanks to "Toby" for all his help & expertise...my old masks now have for-real halo lights again.


            ...
             

            Baddest Tool Chest In Town

            Adios, motor boater!

            ...
             

            Aluminum Repair and Welding

            with our broken moving deck i have been asked to figure out if there is a way we can weld it back together in house for very little expense.
            http://aluminumrepair.com/...
             

            Setting Table Harness Connections

            Hi, guys.

            We recently replaced our setting table harness and when the machine's run in diagnostic mode, we get 01, 02, 03, 04 + 09 errors, or when you place pins...
            Working...
            X