Announcement
Collapse
No announcement yet.
Masking Unit Light Repair
Collapse
Adsense Classic 1
Collapse
TOTY
Collapse
X
-
Masking Unit Light Repair
We have masking units we bought from Horizon Concepts and need some of the 1st/2nd ball light / foul light boards repaired but the phone number we have for Horizon is not any good. Have they went out of business or does anyone know how to contact them or who I might contact to get these boards repaired? any help would be appreciated. ThanksGO THE EXTRA MILE! IT'S NOT THAT MUCH FURTHER.Tags: None
Topic Starter RibbonScript
Collapse
Adsense Classic 2
Collapse
widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.
MP Chassis Tester
Good morning,
I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
I am using relays. My question is to anyone that may...
I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
I am using relays. My question is to anyone that may...
Preventative Maintenance - As, Jets, A2s - LEDs
Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.
www.ledsupply.com...
www.ledsupply.com...
4:1 Timing off..
*sigh* Hello friends..
I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....
I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....
Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.
Left a rant about this in the bowling forum…
I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....
I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....
Turret clutch rebuild
At what thickness do you replace the clutch face.
Is there a minimum dimension from the clutch face to the rivet.
Thanks...
Is there a minimum dimension from the clutch face to the rivet.
Thanks...
Solderless relay conversion
Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...
Comment