No announcement yet.

Wood gutter caps


Adsense Classic 1

  • Filter
  • Time
  • Show
Clear All
new posts

  • Wood gutter caps

    We're replacing our old (Manufacture date of 1960 stamped on underside) wide gutter caps. Does anyone know of a use for our old caps, other than firewood or dumpster stuffing?

  • #2
    Re: Wood gutter caps

    Since no one has responded to this question, I assume that they're trash.


    • #3
      Re: Wood gutter caps

      You can make a pretty cheap teeter-totter out of them for your kids.


      Topic Starter RibbonScript


      Adsense Classic 2


      Related Topics


      • nasty
        Wood Gutter Caps
        by nasty
        I am searching for a couple of sections of wood AMF style narrow division gutter capping. I have had no luck finding any, and the plastic stuff doesn't match with what I have...
        03-30-2007, 06:38 PM
      • Craven
        Wood lane suppliers?
        by Craven
        Since Hoge no longer does woood flat gutters or edgeboards im hoping that someone can point me towards a good supplier of wood lane products. Thank you.
        07-27-2011, 09:19 AM
      • HouseBall
        Wood Gutter Help
        by HouseBall
        I have about 12 lanes equipped with wood gutters. A couple of the gutters have holes and this causing balls to bounce really bad. I have been getting scoring reflectors damaged...
        12-22-2004, 02:23 AM
      • yazu
        sidewalls and flat gutters
        by yazu
        What do you use, if anything to cover these high traffic areas? We put polyureathane on in Sept. 3 coats and it is peeling like sun burned skin. We have phonelic side bds. with...
        12-17-2012, 08:06 PM
      • Jack@C
        need some 3 piece wood gutter
        by [email protected]
        Does anyone know where I can get some 3 piece gutter sections? I am looking for the old narrow kind. Also what is the best paint to use on wood gutters?

        03-15-2006, 01:03 PM

      Stahl's "Tuffy Super Jam Stopper" in action!

      So I decided to try a few of these, I mean the idea totally makes sense and recently I saw these in action and liked what I saw.

      Basically, it's meant as an extension...

      Roller Clutch issue

      Has anyone had to remove the plastic ring in the back side of the plate in order to achieve good indexing? I now have 2 roller clutches without the backing rings in service. Either...

      Pictures of new machines being installed...

      Here are the accelerators and pits that came with the lanes, kickbacks, gutters, power lifts.

      This a new way of building the supports for the lanes...

      Baddest Tool Chest In Town

      Adios, motor boater!


      check this jam...

      the ball stuck the table up