Announcement

Collapse
No announcement yet.

Looking for a part number??

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Looking for a part number??

    Hi Folks,
    I am after a part number that I can't seem to find in the book, it is the saddle block that the main sweep pivot shaft (070-003-106) sits on and has the U-Bolt pass through it to secure the pivot shaft.... I am changing out some stuffed shafts and have some rather dodgy looking blocks....


    Cheers Brett...
    AS REQUESTED....The all new and VERY improved "super cool" Pin_Head with super hip shades.....

  • #2
    found what i think your looking for. In the 90's book. page 5-4 item 36. 000-021-528. Hope this helps
    amf 82-70
    B2000
    quibca

    Comment


    • #3
      Thank brother thats him!!! Stupid me looked at my old manuals didnt have it BUT when I looked at my XLi manual after you mentioned the 90's manual there she is, thanks again mate..
      AS REQUESTED....The all new and VERY improved "super cool" Pin_Head with super hip shades.....

      Comment

      Topic Starter RibbonScript

      Collapse

      Adsense Classic 2

      Collapse

      Related Topics

      Collapse

       

      A2 1 to 1 Gear Box Cover Replacement Due to Crack

      I am refurbishing two converted A2 machines that I will be installing in my home basement this fall. One of them has a leaking gear box and cracked 1:1 gear box cover. I have...
       

      Streamlane Mask Halo Lights

      With huge thanks to "Toby" for all his help & expertise...my old masks now have for-real halo lights again.


      ...
       

      Hybrid (and EcoFriendly) Bumpers (2012)

      It's been about 10 years since we first tried this - 46 lanes and still working fine, auto air bumper cylinders on the BankShot bumpers. Here are videos of a home install with...
       

      Baddest Tool Chest In Town

      Adios, motor boater!

      ...
       

      Aluminum Repair and Welding

      with our broken moving deck i have been asked to figure out if there is a way we can weld it back together in house for very little expense.
      http://aluminumrepair.com/...
       

      Setting Table Harness Connections

      Hi, guys.

      We recently replaced our setting table harness and when the machine's run in diagnostic mode, we get 01, 02, 03, 04 + 09 errors, or when you place pins...
      Working...
      X