No announcement yet.

cycling issue


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • cycling issue

    I have a machine that keeps sweeping off spares. I've been sitting on it for the last two hours and its only happened 8 time. I've tried changing cycle eyes (Bowl-Tronics TC-SUB eye) then I tried disconnecting the tenth frame wires to no avail. Then I caught it cycle once on first ball and it didn't cycle through scoring it cycled as if I pushed cycle on the control box. Could this be in my in my chassi (MP chassis) or could it possible be a bad cycle switch in my control box.

  • #2
    Any chance the sweep is coasting every now & again?
    I've had enough of hope & chains.


    • #3
      Have you eliminated the chassis by changing it?


      • #4
        and its definitly not performing a foul cycle?


        Topic Starter RibbonScript


        Adsense Classic 2

        widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

        MP Chassis Tester

        Good morning,
        I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
        I am using relays. My question is to anyone that may...

        Preventative Maintenance - As, Jets, A2s - LEDs

        Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

        4:1 Timing off..

        *sigh* Hello friends..

        I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

        Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

        Left a rant about this in the bowling forum…

        I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

        Turret clutch rebuild

        At what thickness do you replace the clutch face.
        Is there a minimum dimension from the clutch face to the rivet.


        Solderless relay conversion

        Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...