Announcement

Collapse
No announcement yet.

no pindication

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • no pindication

    No 1st. or 2nd. ball light,no X light & no pin lights. I installed a new omega-tek board (with pindication !)still no lights.{{machine runs fine}}.
    What component is the likely cause? CP1...triac?

    Thanx !
    I never had a "10" ;..but ,one night after closing,..I did five " 2's" !

  • #2
    Re: no pindication

    you dont have the green elco plugs, and the plug is touchy do ya? jiggle the green plug up and down see if you ever get lights.

    Comment


    • #3
      Re: no pindication

      Doesn't the omega tek board bypass the cp1 and the triac? I'd check the green elco as well and also your c1 and c-2a plugs if you have the expander card in there. Good luck!

      Comment


      • #4
        Re: no pindication

        Make sure the ground wire is connected to the machine....usually by a screw to the wireway cover.

        Jerry

        Comment


        • #5
          Re: no pindication

          Yeh,the green flat plug IS touchy on all these(35 year old masks-still pretty as they were painted in a body shop)!

          I've tried all the wiggles possible & can't get the lights to even flash.

          I don't know what gets bypassed by the tek -board...

          Anyone have a wiring diagram for the green plug?

          BTW ...NO expander cards here.

          Thanks

          [ August 22, 2001: Message edited by: Pindecked ]
          I never had a "10" ;..but ,one night after closing,..I did five " 2's" !

          Comment


          • #6
            Re: no pindication

            How about the oll next to the t-2 transformer?

            Comment

            Topic Starter RibbonScript

            Collapse

            Adsense Classic 2

            Collapse
            widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.
             

            Well this is a first.

            We all from time to time have one of those “wow I’ve never seen THAT before” moments. Well today was one of those for me when my night tech texts me to say lane 16 is out...
             

            Ball return wheel guide roller removal.

            Hey guys, i could just use a bit of advice trying to get this part out, first time I've had to do one of these. I got it to move a few turns but its come to a point where it has...
             

            Even old mechanics find something new.

            All my years working on these things I never had this happen…… until last week. ...
             

            82-90XL Frontend Gearbox Parts - Rebuild Woes

            We have 5 of the 088000365 replacement gear kits on the shelf, and I pulled two gearboxes off machines earlier this week, so I thought I'd try my hand at rebuilding them and save...
             

            Prolane damage

            Can this be repaired?
             

            LED Ball Lights

            Made an LED conversion for A2's and Frameworx masks. It can also be modded for the Harmony masks to accept 2 x 5mm led's and/or a 12v supply. Once I'm happy with the performance/design...
            Working...
            X